summaryrefslogtreecommitdiff
path: root/src
AgeCommit message (Collapse)Author
2011-02-21i965: drop state_bo references to batch_boChris Wilson
As we use state relocations and we know that all the state belongs to the same bo, we can drop the multiple references to the same bo. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: directly write wm state to batchChris Wilson
As we write directly into the batch in system memory, we do not need to write first to the stack (as was to avoid read back through the GTT) Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: write cc straight to batchChris Wilson
As we write directly into the batch in system memory, we do not need to write first to the stack (as was to avoid read back through the GTT) Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: switch gen6 to use its own cc state boChris Wilson
In preparation for a greater change, use the color_calc_state_bo already provisioned for this purpose. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21intel: Buffered uploadChris Wilson
Rather than performing lots of little writes to update the common bo upon each update, write those into a static buffer and flush that when full (or at the end of the batch). Doing so gives a dramatic performance improvement over and above using mmaped access. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21intel: Replace the bo for a complete updateChris Wilson
Rather than performing a blit to completely overwrite a busy bo, simply discard it and create a new one with the fresh data. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: Combine vb upload buffer with the general upload bufferChris Wilson
Reuse the new common upload buffer for uploading temporary indices and rebuilt vertex arrays. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21intel: Pack dynamic draws togetherChris Wilson
Dynamic arrays have the tendency to be small and so allocating a bo for each one is overkill and we can exploit many efficiency gains by packing them together. Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21intel: Use system memory for DYNAMIC_DRAW source objectsChris Wilson
Dynamic draw buffers are used by clients for temporary arrays and for uploading normal vertex arrays. By keeping the data in memory, we can avoid reusing active buffer objects and reallocate them as they are changed. This is important for Sandybridge which can not issue blits within a batch and so ends up flushing the batch upon every update, that is each batch only contains a single draw operation (if using dynamic arrays or regular arrays from system memory). Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: Trim the trailing NOOP from 3DSTATE_INDEX_BUFFERChris Wilson
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-21i965: Fallback on encountering a NULL render bufferChris Wilson
Following a GPU hang, or other error, the render target is not likely to have an allocated BO and so we must fallback to avoid using it. Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=32534 Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
2011-02-20i915g: s/__func__/__FUNCTION__/Vinson Lee
2011-02-21i915g: kill remnants of mmapped batchbuffer supportDaniel Vetter
We're using bo_subdata. Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
2011-02-21i915g: Add winsys/i915/sw to scons buildJakob Bornecrantz
2011-02-21i915g: Fix void ptr arithJakob Bornecrantz
2011-02-21i915g: Add dummy flush_frontbufferJakob Bornecrantz
2011-02-20egl_dri2: Return NULL when xcb_get_geometry_reply fails.Chia-I Wu
This should fix bug #33946.
2011-02-19scons: Add aliases for the llvmpipe unit tests.José Fonseca
Now one can simply do scons lp_test_format
2011-02-19gallivm: Use simple scaling plus casting in more unorm->float cases.José Fonseca
2011-02-19glsl: Remove $(PWD) from Makefile in favor of .Kenneth Graunke
Hopefully should fix bug #34468.
2011-02-19r300g: fix a possible race when counting contextsMarek Olšák
Atomics aren't sufficient here.
2011-02-19r300g: fix invalid dereference in winsysMarek Olšák
radeon_bo_unref may destroy the buffer, so call it after p_atomic_dec, not before.
2011-02-18svga: Fix NULL dereference.José Fonseca
Probably introduced with the surface view move from screen to context.
2011-02-18vbo: add debug code to verify that buffers are unmapped before drawingBrian Paul
2011-02-18mesa: MESA_VERBOSE logging for glRead/Draw/CopyPixels, glBlitFramebufferBrian Paul
2011-02-18st/mesa: set renderbuffer _BaseFormat in a few placesBrian Paul
NOTE: This is a candidate for the 7.9 and 7.10 branches
2011-02-18st/mesa: check buffer orientation in blit_copy_pixels()Brian Paul
Can't invert the region if copying between surfaces with different orientations.
2011-02-18svga: Ensure pending drawing commands other surface operations are emitted ↵José Fonseca
before DMAs. This behavior was last when moving the transfers to the contexts. This fixes several piglit failures, which were reading the color renderbuffer before the draw operations were emitted.
2011-02-18svga: Cannot use negate or abs on source to dsx/dsy instructions.José Fonseca
2011-02-18svga: Ensure SWTNL is created after HWTNL.José Fonseca
Matches the internal driver layering, and prevents null svga->hwtnl dereferencing from inside the swtnl.
2011-02-18svga: Ensure LRP's restrictions are observed in all uses.José Fonseca
The dst reg must be a temporary, and not be the same as src0 or src2.
2011-02-18svga: Preserve src swizzles in submit_op2/3/4.José Fonseca
Several opcodes require scalar swizzle, and this requirement was being was not being observed when creating temporaries for other reasons.
2011-02-18r300g: remove tracking whether vertex buffers need to be validatedMarek Olšák
This was getting hard to maintain and didn't really bring any real benefits. Instead, validate buffers when the vertex array state is dirty.
2011-02-18st/mesa: fix geometry corruption by always re-binding vertex arraysMarek Olšák
This is a temporary workaround. It fixes sauerbrauten with shaders enabled. I guess we might be changing vertex attribs somewhere and not updating the appropriate dirty flags, therefore we can't rely on them for now. Or maybe we need to make this state dependent on some other flags too. More info: https://bugs.freedesktop.org/show_bug.cgi?id=34378
2011-02-18svga: Disable surface cache for texturesJakob Bornecrantz
Signed-off-by: Jakob Bornecrantz <jakob@vmware.com>
2011-02-18svga: Describe svga_sampler_views for refcnt debuggingJakob Bornecrantz
Signed-off-by: Jakob Bornecrantz <jakob@vmware.com>
2011-02-18svga: Make sure that refcnt debugger gets the correct backtrace for createJakob Bornecrantz
Signed-off-by: Jakob Bornecrantz <jakob@vmware.com>
2011-02-18util: Make refcnt and symbol debuggers work on windowsJakob Bornecrantz
Signed-off-by: Jakob Bornecrantz <jakob@vmware.com>
2011-02-18Point to bugs.freedesktop.org rather than bugzilla.freedesktop.orgCyril Brulebois
Suggested by a freedesktop.org admin. Signed-off-by: Cyril Brulebois <kibi@debian.org>
2011-02-18u_vbuf_mgr: initialize flag indicating that buffers have been updatedMarek Olšák
This fixes r300g errors: r300: Cannot get a relocation in radeon_drm_cs_write_reloc.
2011-02-18gallium/svga: Fix unnecessary swtnl fallbacksThomas Hellstrom
When we drop the in_swtnl_draw flag, we must force a rerun of update_need_swtnl to reset the need_swtnl flag to its correct value outside of a swtnl vbo draw. Signed-off-by: Thomas Hellstrom <thellstrom@vmware.com>
2011-02-18r600g: reorganise rgtc pieces.Dave Airlie
when the cs checker fixes go upstream a lot of this can disappear into a drm version check. Signed-off-by: Dave Airlie <airlied@redhat.com>
2011-02-17st/mesa: implement blit-based path for glCopyPixelsBrian Paul
If doing a simple non-overlapping glCopyPixels with no per-fragment ops we can use pipe_context::resource_copy_region().
2011-02-17mesa: fix comments for _mesa_clip_readpixels()Brian Paul
2011-02-17st/mesa: indentation fixBrian Paul
2011-02-18r600g: Start a new TEX clause if the texture lookup address was fetched in ↵Fabian Bieler
the current clause Signed-off-by: Dave Airlie <airlied@redhat.com>
2011-02-18r600g: Add support to dump vertex- and texture-fetch clausesFabian Bieler
Signed-off-by: Dave Airlie <airlied@redhat.com>
2011-02-18r600g: add BC4/5 to RGTC conversionDave Airlie
this doesn't do anything much since the rest of mesa doesn't support RGTC yet.
2011-02-17util: Fix typo in last commit.José Fonseca
2011-02-17st/mesa: fix incorrect glCopyPixels position on fallback pathBrian Paul
If we hit the pipe_get/put_tile() path for setting up the glCopyPixels texture we were passing the wrong x/y position to pipe_get_tile(). The x/y position was already accounted for in the pipe_get_transfer() call so we were effectively reading from 2*readX, 2*readY. NOTE: This is a candidate for the 7.9 and 7.10 branches.